In short
A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Ardsley, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Doors that won't close in Ardsley
Ardsley is a small village with two waterways, the Saw Mill River and the Sprain Brook, and the Saw Mill has flooded homes here repeatedly. On the Saw Mill River side, garages that have taken water end up with corroded sensors and wiring weeks afterward, and cleaning does not bring them back. In Ardsley Acres and on Beacon Hill, mid-century houses sit on slopes with garages underneath, where runoff and leaves collect at the threshold. Around Concord Road and Winding Road Farm, attached garages are busy with bikes and bins. Road spray and salt from the Saw Mill Parkway and the Thruway also film the lenses in winter.
Why a garage door refuses to close
- Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
- Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
- Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
- Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.
Three safe checks before you call
- Look at the small lights on both sensors. Each should be on and steady.
- Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
- Gently turn the blinking sensor until its light goes steady, then try the remote again.
If that doesn't do it, stop there. Don't tape the sensors together or bypass them.
Fixing it properly
Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.
Around Ardsley
- Saw Mill River side: Streets near the river and Macy Park, where flooding has been a concern.
- Winding Road Farm: Larger newer homes with wide attached garages.
See the full Ardsley service area.